Using a Mac with at least OS X 10.6.8 installed, access the Mac App Store and download the Mavericks (10.9) app installer. Insert the USB drive into the Mac and launch Disk Utility. So I downloaded myself a OSX install ISO and then went to burn it. To my utter shock it was slightly bigger than what could fit on the blank DVD’s I had. So I tryed to mount it to a USB and make it bootable. I do not have any Macs or anything running OSX, apparently it is easier to do from Mac OS, on windows it is a little bit more difficult. In other words, there is more than one way to create a USB flash drive installer from a Snow Leopard ISO file. The steps below are for OS X and macOS. Use the command given below to determine the identifier for the flash drive. Diskutil list Enter the commands given below to create the USB flash drive installer. In this post I’ll show how to create a bootable ESXi Installer USB flash drive on macOS without any 3rd party software. I’ve done this many times on Windows using Rufus, but here i’ll demonstrate how it can be done on macOS without 3rd party software. See updated post Create a Bootable ESXi 7 USB Installer on macOS with video. Windows 10 bootable USB vs Linux ISO USB. Windows 10 is a very specific bootable media, so the process is a bit involved. For generic Linux installation ISOs this procedure would be simpler. So the first two steps are the same, then Windows and Linux have separate procedure. Here’s what we will do for Windows ISO.
|Files||Yosemite_Hackintosh.iso (5.50 GB)|
Mac Os Iso File Bootable Usb
Iso To Bootable Usb Osx
Mac OS X – Yosmite (Hackintosh)
Mac OS X Yosemite Hackintosh
System Requirements: OS X Yosemite 10.10.1 (Build: 14B25) is compatible and supported by following computer hardware systems.
Intel Based Processors AMD Based Processors Installed on Windows Only i.e.(Windows 10,Windows 8.1, Windows 8, Windows 7, Windows Vista, Windows XP)
Minimum 2 GB of RAM
Minimum 8 GB of Hard Disk Drive (HDD)
Step 1: Download Hackintosh OS X 10.10.1 Yosemite .ISO File for Windows
Step 2: Mount the Hackintosh ISO Image File i.e. 10101usb.iso.
Step 3: Install R-Drive (in the hand).
Step 4: Now expand the image 10.10.1.usb.arc to any Bootable USB flash drive or Bootable DVD for manual installation.
Step 5: After that, Specified during installation to become the partition active.
Step 6: Now, reboot, load with flash to make Mac OS X installation.
Step 7: When installation gets complete, reboot again with the USB stick or DVD, but choose a boot menu section with a freshly installed Mac OS X Yosemite.
Step 8: Now, after download completes successfully – install the boot loader and the necessary kekstov. Congratulations!! You’re done